Com Kawasaki Z1, KZ900, KZ1000. New MTC Engineering Big Bore Piston Kit, 1075cc. This listing is for a complete MTC Engineering.It's official designation is PSP-MTC-K1075. The dome on this piston is exactly one half the height of the dome on the standard MTC-K1075 piston.
This smaller dome was designed by PitStopPerformance. Com to lower the cranking compression of the motor when used with stock camshafts. What is more important to the rider of the motorcycle than compression ratio is the cranking compression with whatever camshafts are installed.
When a camshaft with longer duration is installed the cranking compression of the motor will be reduced regardless of the type of piston installed. Com will rate our KZ pistons according to the standard cranking compression expected with a particular set of camshafts installed. The PSP-MTC-K1075 piston kit is intended to be used with stock camshafts and the advertized cranking compression will be based on that application. This piston kit has 10.5:1 cranking compression when used with stock camshafts. These pistons are manufactured in Cocoa Florida using the highest quality aluminum alloy.Each piston is subjected to a battery of quality control checks to assure uniformity and high quality. Some of the world's fastest motorcycles are equipped with MTC Engineering pistons. This MTC Engineering piston kit contains the following: (4) 72mm aluminum forged pistons, 10.5:1 cranking compression with stock camshafts (4) Hard chromed wrist pins. (4) Sets of 72mm rings.
(with three piece oil ring) (8) Teflon buttons sized for a 72mm bore. (buttons take the place of circlips) (1) Cometic two piece fiber head gasket with chain galley o'ring. If you have ever seen what a dislodged circlip can do to a piston and cylinder, you would never use them again. The picture shows a single piston. You get all of the parts listed above.This piston kit will fit Kawasaki Z1, KZ900 and KZ1000 models. For use on a Z1 or KZ900 either the sleeves must be changed in the 903cc cylinder, or a KZ1000 cylinder must be used. This covers all models from 1973 through 1980. The pistons have 17mm wrist pins.
They have valve reliefs sized for 39mm intake valves and 33mm exhaust valves. Com offers a complete machine shop service. Com can provide you with any product made by: MTC Engineering , American Performance Engineering (APE) , Murdoch Racing Enterprises (MRE) , or Schnitz Racing.
The item "PSP-MTC-K1075 Kawasaki Z1 KZ900 KZ1000 Big Bore Piston Kit 1075cc" is in sale since Monday, February 8, 2010. This item is in the category "eBay Motors\Parts & Accessories\Motorcycle Parts\Other Motorcycle Parts".
The seller is "jjhooper" and is located in Orlando, Florida. This item can be shipped worldwide.